Saab 9-3 M03-900 Installation instructionsSCdefaultMONTERINGSANVISNING · INSTALLATION INSTRUCTIONS MONTAGEANLEITUNG · INSTRUCTIONS DE MONTAGESITdefaul
10 12 788 928Saab 9-3 M03-27 Fit the hose clips (including the old clip) onto thenew coolant hoses. Connect the hose/pipeassembly between the thermost
12 788 928 11Saab 9-3 M03-38 Remove the wiper arms using puller 85 80 144.Remove also the bonnet seal and the cover overthe bulkhead space.F920A018383
12 12 788 928Saab 9-3 M03-39 Locate the "Pre Acc" outlet between the enginebay main fuse box and the front wing andremove any adhesive tape
12 788 928 13Saab 9-3 M03-45 Raise the car.46 Pull down the fuel pump wiring harness.47 Thread the fuel pump fuel line up between theheater and the lo
14 12 788 928Saab 9-3 M03-51 Position the fuel pump bracket up against thevehicle floor, on the right-hand side in front ofthe fuel tank, and drill ho
12 788 928 15Saab 9-3 M03-58 Manoeuvre the heater exhaust pipe up towardsthe heater and fit the end of the pipe onto theexhaust port of the heater. Fa
16 12 788 928Saab 9-3 M03-61 Fit the heat shield to the turbo compressor (twoscrews and a catch).62 Fit the turbo intake pipe and then connect to thep
2 12 788 928Saab 9-3 M03-Heater mounting kit1 Petrol heater2 Holder3 Exhaust system4Bolt M6x1005 Nut M8 (x3)6 Nut M6 (x2)7 Coolant hoses/pipes8Bolt9 H
12 788 928 3Saab 9-3 M03-Fuel line kit1 Fuel line (pump-heater)2 Fuel line (tank to pump)F920A01212
4 12 788 928Saab 9-3 M03-Electrical connection kitWiring harnessF920A013
12 788 928 5Saab 9-3 M03-ImportantWARNINGWork on the heater involves dismantling the vehi-cle fuel system and emptying the fuel tank. Whencarrying out
6 12 788 928Saab 9-3 M03-PreparationsReduction of fuel pressure1 Let the engine idle.2 Remove fuse No. 2 (fuel pump) from the electri-cal centre locat
12 788 928 7Saab 9-3 M03-1 Disconnect the negative battery cable.2 Remove the cap from the expansion tank.3 Raise the car.4 Remove the bolts from the
8 12 788 928Saab 9-3 M03-7 Unplug the connector at the front of the fuel tankand detach the wiring harness from its mounting.8 Place a pillar jack und
12 788 928 9Saab 9-3 M03-22 Unplug the connector from the air mass sensor,separate the intake hose and remove the air fil-ter cover. Remove the hose f
Commentaires sur ces manuels